Cisco PIX/ASA Security Appliance: How to Configure Banners - In the following...

(Page 3 of 4 )

In the following hands-on exercise, you will create MOTD, login, and EXEC banners.

Step 1: In configuration mode, enter the following commands:

asa(config)#banner motd This is the MOTD banner
asa(config)#banner login This is the login banner
asa(config)#banner exec This is the EXEC banner

Step 2: Display the banners you just created with the following command:

asa(config)#show running-config banner

Step 3: Type exit repeatedly until you are logged out of your laboratory security appliance.

Notice which banners are displayed.

Step 4: Enter privileged mode with the command "enable" and notice which banners are displayed.

Step 5: From your laboratory computer, start a Telnet session and again observe which banners are displayed. When you are finished, exit the Telnet session.

Next: Also from your... >>
 

More Website Marketing Articles
More By Jase Dow